Comtrol AT Commands for SmartACFL Instrukcja Użytkownika Pobierz pdf (Strona 113)

Command Reference Manual

100722A

Conexant

4-7

4.2.2.6 +FRM - Receive Facsimile

This command causes the modem to enter the receiver mode using the modulation defined below.

Syntax

+FRM=<mod>

Defined Values

<mod> Decimal number corresponding to the selected modulation mode and data rates shown in Table

4-2.

Reporting Current or Selected Values

Command: +FRM?

Response: +FRM: <mod>

Example: +FRM: 98 For V.17 9600 bps.

Reporting Supported Range of Parameter Values

Command: +FRM=?

Response: +FRM: (<mod> range)

Example: +FRM: 3,24,48,72,73,74,96,97,98,121,122,145,146

Result Codes

CONNECT Reported when the selected carrier is detected.

+FCERROR Reported if another carrier is detected and FAR=0; the modem then returns to the command state.

NO CARRIER Reported if loss-of-carrier is detected.

OK Reported if the DTE sends any character to the modem other than XON or XOFF while operating

in configured flow control from the DTE; the modem then returns to the command state.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 171 172

Brak uwag

Comtrol AT Commands for SmartACFL Instrukcja Użytkownika Strona 113